The ridge ventilator is mainly installed on the roof of the factory to provide an excellent ventilation and smoke exhaust environment for the workshop to ensure the comfortable factory environment. However, the design and manufacture of roof ridge vent must comply with the manufacturing requirements of steel roof ridge vent in addition to strictly in accordance with customer requirements.
1. The ridge ventilator is mainly composed of the framework, the outer guard plate, the end plate, the rainproof plate, the flooding plate, the drainage groove and other components.

2. The roof smoke vent has a curved structure with good rigidity, strength and air flow performance.

3. The rainproof board can effectively prevent rainwater from entering the workshop and can withstand the long-term erosion of rainwater. Especially the Mcwell's full-structure waterproof technology has significant effects on the roof skylight in rain, snow, and leak prevention.

4 The drainage channel of the steel roof ridge vent can quickly discharge rainwater, preventing rainwater from entering the room, affecting the indoor environment, and providing guarantee for indoor drying and equipment safety.

5. The flooding board can completely drain the rainwater out of the roof waterproof layer, and at the same time can prevent the roof rainwater from splashing into the room.

6. The seller shall provide the detailed design drawings of the roof ventilation skylight products as much as possible, and realize the welding with the roof steel beams on this basis.

7. The components made of section steel and plates should be flat and straight, because the burrs produced by cutting should be clear and proper, and the acute angles formed should be blunt to ensure that there are no acute angles on the surface after installation.

8. The production size of the roof skylight equipment should be gentle with the installation size of the equipment, and the installation layout and installation nodes should be installed in accordance with the drawings.