The finished light-duty roof lighting ventilator refers to the ridge ventilator installed on the roof of the factory building with a small self-weight load. Usually refers to the small throat streamlined natural ventilator installed down the slope, which is evenly arranged on the slope of the workshop in strips, so the ventilation and lighting are more uniform. Today, the editor of Mcwell introduces the key points of its design.

structural safety

The structural safety of the finished light-duty roof ridge ventilator refers to the main force-bearing parts of this type of ventilator, the material selection of each component and the connection nodes, which meet the wind load, snow load and seismic grade requirements of the project location, even in extreme weather, It can also operate normally, and its service life is guaranteed to be the same as that of the plant. The process of checking the structural safety of the downhill ventilator is also the process of determining its material configuration.

Specification and quantity

Different workshops have different requirements for ventilation and smoke emission and lighting. Therefore, the specification and quantity of the steel roof ridge vent should be affected by the actual needs of the workshop. It is necessary to avoid waste and effective ventilation and smoke emission. 

Whether to configure electric valve plate

If the workshop needs to control the amount of ventilation and smoke or needs to be insulated, then it needs to be equipped with an electric opening and closing valve plate. The price of the open-close downhill ventilator with the electric valve plate is higher than that of the roof ventilator without the electric valve plate.